PAINT MASKS for the 350 Scale U.S.S. ENTERPRISE REFIT Shuttle Bay Landing Floor
What do you get? You get FOUR masks with the set. Now included are three extra masks to help you get it just right for your Refit build! I believe it's always good to have extras in case you make mistake. You also get two pieces of transparent transfer tape to transfer the mask from the backing to the model part.
You will need to apply the transfer tape to the mask and rub the tape down where the is not bubbles or spaces left. You then use the tape to pull the mask off the backing material by pulling back the tape over itself very slowly to make sure the mask comes of onto the tape. Sometimes you’ll have to push the tape back down and rub the transfer tape back onto the mask. This may take several tries to get it right.
You then apply the mask on the tape to the kit part and rub the tape/mask down until there is no air voids left. Then slowly peel the tape off leaving the mask on the part. This can take several tries to get the mask to set. Peel slowly, rub back down, peel, rub, peel until you can remove the tape with the mask left on the kit part.
This mask can be used as a negative or a positive mask. The use of painting masks is considered an advance modelling skill and may require practice to master.
Paint Mask Instruction Video: Please watch the instruction video on how to use these masks. You can access the video on our product instruction page which can be viewed here:
REFIT SHUTTLE BAY PAINT MASK INSTRUCTIONS