V.I.N.CENT. ROBOT BLACK HOLE REPLACMENT DECALS for the MPC kit by HDAmodelworx

V.I.N.CENT. ROBOT BLACK HOLE REPLACMENT DECALS for the MPC kit by HDAmodelworx

These replacement decals include every decal needed for the kit, along with multiple eye options. They are designed to be thinner and slightly less opaque than the original kit decals. Because of this, they are printed differently from most of our other decals and require less water during application.

Application Instructions:

Each decal number matches the corresponding number on the kit decals. There are also additional unnumbered eye decals that provide a separate white background and pupil. This allows for a subtle layered look, similar to the original studio prop.

IMPORTANT NOTICE:

These decals should be applied using the spray wetting technique (do not soak them in a dish of water):

1. Place the decal on a paper towel.
2. Spray water on the back, then on the front.
3. Wait until the decal loosens from the backing paper.
4. Gently slide the decal onto the model’s surface.
5. Once positioned, gently pat it down with a dry paper towel to help it conform to the surface.

Tips:

• Because of the ink used, avoid pulling too much of the decal off the backing at once to prevent curling.
• If the decal hasn’t fully settled, continue gently patting it down with a paper towel.
• Setting solution is usually not needed, but if you choose to use it, apply it very lightly.