5 PACK 0805 FLICKERING SMDs
The new SMDs are provides a flickering effect just like a normal flickering 5 or 3mm LED, but in a much smaller formfactor. Great for use in tight locations on a model where a flickering effect is need, but where there isn't enough room for a normal LED. Our Pre-Wired SMDs (Surface Mount Device) are only 2mm x 1.25mm and comes with cables soldered onto the backside or sides allowing the wiring to lay flat in the same direction. Soldering SMDs is very difficult, but these pre-wired units take all the work out of it for the modeler. Each unit comes with its own inline resistor (1,000 Ohm) for 12v-18v operation. These units will also light up at 9v, but will be slightly dimmer.
- Size: 0805 SMD LED (2.00mm x 1.25mm)
- FX: Flickering
- Wire leads are about 20cm in length
- Forward Voltage: 9v -12v
- Forward Current (typ/max): 15mA/20mA
- DC Operation
- Light Color: GREEN