5 PACK 3020 SMD BLUE WITH SOLDERED RESISTOR AND WIRE LEADS
Our 3020 Pre-Wired SMDs (Surface Mount Device) are only 2mm x 1.25mm and comes with cables soldered onto the backside or sides allowing the wiring to lay flat in the same direction. Soldering SMDs is very difficult, but these pre-wired units take all the work out of it for the modeler. Each unit comes pre-soldered with resistor (1,000 Ohm) for 12v operation. These units will also light up at 9v, but will be slightly dimmer.
- Size: 3020 SMD LED (about 3.00mm x 2mm)
- Wire leads are about 15cm in length
- Forward Voltage: 3.2 typical
- Resistored for 12v operation; works at 9v
- Reverse voltage: 5v
- Brightness rating: 600 MCD
- View Angle: 120 degrees
- DC Operation
- Light Color: BLUE